Permatex Ultra Copper RTV Silicone Gasket Maker
泰扬超铜RTV硅制垫片胶
Permatex Ultra Copper RTV Silicone Gasket Maker
泰扬超铜RTV硅制垫片胶
可承受的最高间隙工作温度为371℃,其填补缝隙最大可达6mm,该产品具有超强的粘性,其防油能力是普通硅胶的3倍,其弹性是一般垫片的8倍。
包装规格
型号 | 包装规格 | 每箱数量 | 产品代号 |
81878 | 3盎司卡式管装 | 12 | 81878 |
85088 | 8.75盎司PowerBead罐装 | 6 | 85088 |
82751 | 300毫升卡桶 | 6 | 82751 |
PRODUCT DESCRIPTION Permatex Ultra Copper is a single component, room temperature vulcanizing gasketing compound designed to provide reliable “formed-in-place” gaskets for mechanical assemblies. This material cures on exposure to moisture in the air to form a tough, flexible, silicone rubber gasket. The product resists aging, weathering and thermal cycling without hardening, shrinking or cracking. Permatex Ultra Copper is the most advanced high performance, high temperature (up to 700F intermittent) RTV gasket available. PRODUCT BENEFITS ● High temperature resistance ● Sensor safe, non-corrosive ● Superior adhesion and flexibility ● Replaces most cut gaskets ● Improved oil resistance ● Can be used as a gasket maker or dressing ● Non-flammable, Non-toxic ● Low odor TYPICAL APPLICATIONS ● Pumps ● Compressors ● Exhaust manifolds/headers ● Valve covers ● Oil pans ● Thermostat housings ● Gearboxes DIRECTIONS FOR USE For assembly as form-in-place gasket 1.Remove all previous material from mating surfaces. Permatex Silicone Stripper or Gasket Remover is re commended for most materials. 2. For best results, clean and dry all surfaces with a res idue-free solvent, such as Permatex Brake and Par ts Cleaner. 3. Cut nozzle to desired bead size, 1/16 “ to 1/4 “ in diameter. An 1/8” bead is usually sufficient for mo st applications. 4. Remove cap, puncture tube or cartridge seal and at tach extension nozzle. 5. Apply a continuous and even bead of silicone to on e surface, first tracing the internal areas of the gask et configuration, then all surrounding bolt holes as shown below: 6. Assemble parts immediately while silicone is still we t. Secure or tighten to recommended torque specs. 7. Re-torque will not be necessary after the product h as cured. |
●避免与皮肤及眼睛直接接触,请于使用时戴上塑胶手套及安全护目镜。
●若因接触皮肤引起过敏及红斑,请以肥皂及清水沖洗;若不慎触碰到眼睛时,请立即以清水沖洗并就医诊查
●勿吞食、勿让孩童取用。
●使用本材料的工作环境须通风良好,勿在密闭空间使用。