型号

包装规格

每箱数量

产品代号

PRODUCT DESCRIPTION

Permatex SUPER "300" FORM-A-GASKET Sealant is a

black, free flowing liquid with a characteristic alcoholic

odor.It is an olen-resinous, fast drying, non-hardening.

semi-flexible sealant for all types of assemblies with 

or without gaskets. Remains tacky after solvent evaporation.

PRODUCT BENEFITS

●For use on all types of gaskets

●Non-hardening

●Seals threads and hoses

●Excellent oil resistance

●Applies easily

TYPICAL APPLICATIONS

●Compressors

●Diesel engine heads

●Final drives

●Gear boxes

●Power units

●Pumps Transmissions

●High speed turbine Superchargers

DIRECTIONS FOR USE

FOR assembly as form-in-place gasket

1.Remove al previous material from mating surfaces.

   Permatex Gasket Remover is recommended for most

   materials, not for plastics or painted surfaces.

2.For best results, clean and dry all surfaces with a resi

   due-free solvent, such as Permatex Brake and Parts 

   Cleaner.

3.Apply a thin, continuous and even bead of product 

   to both surfaces to be sealed, First tracing the inter

   nal areas of the gasket configuration, then all surr

   ounding bolt holes as shown below.

4.Allow to air dry for 5 to 10 minutes.

5.Assemble parts immediately while the product is still

   wet. Secure or tighten to recommended torque spe     

   cs. Allow 1 hour at room temperature before use.

   Note:Slight warming decreases drying time.

For Cleanup

1.Remove uncured product from parts and hand-tools with

   a dry cloth, if skinned over, break film with a cloth to

   remove as much as possible, and remove the remaining

   material with Permatex Gasket Remover as previously

   stated.

2.Clean hands with a dry cloth or Permatex Fast Orange

   hand cleaner.

PROPERTIES OF UNCURED MATERIAL

                                                             Typical Value

Chemical Type                          Polymerized vegetable oils

Appearance                                      Black Paste

Odor                                                 Alcoholic

Specific Gravity                                     1.0

Viscosity                                 Flow similar to SAE 40 Motor oll

Flash Point, TCC -F                               76

GENERAL INFORMATION

This product is not recommended for use in pure oxygen

and/or oxygen rich systems and should not be selected as

a sealant for chlorine or other strong oxidizing materials.

For safe handling information on this product, consult the

Material Safety Data Sheet,(MSDS).

STORAGE

Products shall be ideally stored in a cool, dry location in

unopened containers at a temperature between 8 to 28 ℃

(46 to 82℉)unless otherwise labeled. Optimal storage is at

the lower half of this temperature range. To prevent con

tamination of unused product, do not return any material

to its original container.

NOTE

The data contained herein are furnished for information only

and are believed to be reliable. We can not assume responsi

bility for the results obtained by others over whose methods

we have no control. Permatex Inc.specifically disclaims all

warranties expressed or implied, including warranties of me

rchantability or fitness for a particular purpose, arising from

sale or use of Permatex, Inc.frproducts and disclaims any 

liability for consequential or incidental damages of any kind,

including lost profits. This product may be covered by one

or more United States or foreign patents or patent applications.